© 2019  Kurt Stoeckli,  all Rights reserved

Swiss Seaplane Pilot for Prepar3D V4
Service Pack 2  (Service Pack 1 included)

I have properly installed Swiss Seaplane Pilot in Prepar3D V4, but I can not see the frozen lake surfaces.

See also frequently asked questions

If I want to launch the german speeking mission "Greyerzersee - Schwarzsee", an error message occurs (see image below), the mission can not be startet.


During the landing procedure of the same mission in French or English, I am instructed to lower the water rudder instaed of the landing gear to land on the frozen lake.


The welcome message of two missions are fired somewhen during the mission instead at the beginning.